.45 Cowboy Special Load Data & Reloading Guide
Also known as: .45 CS, .45 SPL, C45S
About .45 Cowboy Special
The .45 Cowboy Special is a rimmed, straight-walled revolver cartridge built on a .45 ACP length case (0.898 in) with a revolver rim. It was created for cowboy action shooting so that shooters could use one bullet and similar loads in revolvers fitted with a matching cylinder, while keeping recoil mild.
It fires .452 in bullets, typically 200 to 230 grains at moderate velocities. There is no official SAAMI or C.I.P. standard, so dimensions and pressure follow established wildcat practice.
For reloaders the small case works well with fast pistol powders and large pistol primers. Keep loads within the low pressure limits suitable for revolvers chambered for this cartridge.
Technical Drawing
Based on SAAMI, the max. allowed case length is 0.898 in / 22.81 mm, the max. cartridge length is 1.230 in / 31.24 mm, and the max. allowed pressure is 14,504 PSI / 1,000 bar.
Technical Specifications
Start Calculating to Develop your own Load Data for .45 Cowboy Special
Use our professional ballistics calculator to develop safe and accurate load recipes for .45 Cowboy Special.
Start CalculatingStandard Load Data — .45 Cowboy Special
Select your desired cartridge and bullet weight below to access the corresponding load table. From there, you can choose any listed load recipe and transfer it directly into the ballistics calculator for further refinement, optimization, and precision tuning.
.453 | 244gr | NOE Bullet Molds RF GC AB4
.452 | 250gr | Rim Rock RNFP Top Shelf
.451 | 225gr | X-TREME FP
.452 | 250gr | H&N KS HS
.452 | 250gr | ACME RNFP LUBED
.452 | 200gr | Rim Rock RNFP Top Shelf
.452 | 200gr | Rim Rock RNFP
.452 | 230gr | X-TREME RN
.452 | 230gr | LEE Mold TL452-230-TC
.452 | 200gr | H&N KS HS
.451 | 230gr | Hornady FMJ FP
.451 | 250gr | Rim Rock RNFP
.452 | 180gr | Rim Rock RNFP Cowboy
.452 | 230gr | ACME RN NLG COATED
.452 | 230gr | X-TREME RP HP
.451 | 200gr | Hornady XTP
.452 | 250gr | Target Bullets FPPB
.451 | 200gr | Rim Rock SWC Top Shelf
.452 | 201gr | NOE Bullet Molds RN PB AM6
.454 | 243gr | NOE Bullet Molds RF PB AC3
.451 | 185gr | Rim Rock SWC
.452 | 200gr | Hornady SWC
.451 | 230gr | X-TREME RN
.451 | 200gr | Lehigh Defense Extreme Penetrator
Frequently Asked Questions
The maximum pressure for .45 Cowboy Special is 14,504 psi | 1,000 bar.
.45 Cowboy Special typically uses a Large Pistol (LP) primer.
The case capacity of .45 Cowboy Special is approximately 25 grains of water (H₂O).